Page 1 of 1
Connectors crossing
Posted: Thu Jun 11, 2009 6:32 pm
by sikra
I need a little help. When two connectors are crossing is there a possibility to make this crossing with litle curve ( you know like in Visio) or it can be only done in straight crossing mode. Thank You. Daniel
Re: Connectors crossing
Posted: Thu Jun 11, 2009 8:09 pm
by acknak
Sorry, OOo does not support connector crossings at all.
It has been requested:
Issue 81290:
smart connectors when crossing another connector
You can register there and add your vote (up to two) or comment.
Re: Connectors crossing
Posted: Fri Jun 12, 2009 5:40 pm
by roadbike
Although it would entail more work, you can create a semi-circle by:
Select Basic Shapes>Circle Pie.
Create a half circle, change the fill to none.
Modify>Break then Modify>Break again and then delete the 2 line segments.
Add this item to your gallery for easy access.
Drop it over the line you want to cross and then use line segments on either side.
I have to use a similar method for rounding corners of lines when they meet at 90 degrees since Draw lacks the ability to round corners.