Apache OpenOffice Community Forum

I am doing a diorama and want to round one or more corners on floor plans. There is no problem getting four corners (on aretangle) but limiting rounding to one only seems out of the question. I solved this by adding squares to conrers and grouped the results, however now I can't get rid of the lines around the squares

Edit: Changed subject, was Rounded corners  Make your post understandable by others  -- MrProgrammer, forum moderator

After you position the small squares, select the entire set of shapes by clicking and dragging an area larger than the object. Right click and select Shapes -> Merge. You should end up with a single shape that has sharp corners where the squares were.

FJCC wrote:After you position the small squares, select the entire set of shapes by clicking and dragging an area larger than the object. Right click and select Shapes -> Merge. You should end up with a single shape that has sharp corners where the squares were.

I'll have try that tomorrow and thanks for the reply.