Defining initial form state

tcrabb · Post by **tcrabb** » Wed May 14, 2008 4:39 pm

Is it possible to define the initial form state as being maximised to full screen area and correct position?

At present it is opening at near full size but not quite and offset so part is off the screen. This is annoying to say the least.

I am runnning OOo 2.40 under WinXp if that makes a difference.

An info appreciated.

tcrabb · Post by **tcrabb** » Wed May 14, 2008 4:43 pm

Just noticed the post earlier advising use of macros - I will try using this code unless there is an easier way?

Suprised you cannot define this within the page properties configuration box.

Defining initial form state

Defining initial form state

Re: Defining initial form state