[SOLVED] Row Height Keeps Changing After Save

[Nancy514327]

My document contains four pages of Tables. The height of all Rows look perfect upon Saving but when I open the file again, Page 2 only contains Row 1 (the rest of page is blank).

When I check the Row Height of only Row 1 on Page 2, it is either .5 or .34 and Fit to Size is checked. All the other rows are .01 and Fit to Size is checked. If I move the bottom line of the Row 1 up a tiny bit, the rest of the rows, that should be on that page, move up and document is correct again. When I Save and open the file again, I still get only Row 1 on Page 2.

I have highlighted all rows, page by page, Right Clicked and made sure the Row Height is .01 and Fit to Size is checked. If I Save and Open again, Page 2 only has Row 1...again.

While I can get by with adjusting the line to fix to the problem, I would like to know how to correct it.

Thanks in advance.
Nancy

[RoryOF]

Format in which you save?

[Nancy514327]

.odt

[Bill]

Did you try unchecking "Fit to Size" for row 1?

[Nancy514327]

I probably didn't try that as I was thinking the rows should all be set up the same way. Following your suggestion, I unchecked the Fit to Size box. The subsequent lines on Page 2 moved up to their correct place, but the bottom two rows of each page needed to be adjusted due to the 'move up'.

After saving and opening again, Page 2 loaded properly. That Row 1 Height is still .01 and the Fit to Size box is checked again but at least it WORKS!!!

Thanks so much for the suggestion.

Nancy