Apache OpenOffice Community Forum

I have a existing OO DB but when I create a report and print it the first table is wide the next smaller.... I would like to adjust the widths but there is no adjuster coming up using my curser and I do not see a way when you create a report (it uses a wizard).
Thanks much

Hi,

Are you using the Oracle Report Builder?
If that's the case you can set your page size select Format --> Page.
If you have adjusted the page size the screen doesn't show the new size, you have to close your report (after saving) and reopen it.

Martin

I an a little confused I am only using the OO3 and when I open a exsiting DB there is on the left side boxes (table, form, report...) and I check reports then I see no other options is this from a pull down in the report mode or> Thx again