Page 1 of 1

Breakpoints refuse to go away

PostPosted: Sun Oct 08, 2017 11:00 pm
by bongbang
Using LO's standard editor/IDE to write macros, I can set breakpoints to stop execution where I want, but I cannot unset them. I can make the red circles disappear alright, but the macro would still stop where they were, as though the break points are still there. This, after opening "Manage Breakpoint to make sure everything is gone.

The breaks go away if I close the editor/IDE, only to come right back when it is reopened. They're nothing if not persistent, these breakpoints.

How can I get rid of these breakpoints (short of restarting the LO application)? Thank you.