Connectors crossing

[sikra]

I need a little help. When two connectors are crossing is there a possibility to make this crossing with litle curve ( you know like in Visio) or it can be only done in straight crossing mode. Thank You. Daniel

[acknak]

Sorry, OOo does not support connector crossings at all.

It has been requested: Issue 81290: smart connectors when crossing another connector
You can register there and add your vote (up to two) or comment.

[roadbike]

Although it would entail more work, you can create a semi-circle by:

Select Basic Shapes>Circle Pie.

Create a half circle, change the fill to none.

Modify>Break then Modify>Break again and then delete the 2 line segments.

Add this item to your gallery for easy access.

Drop it over the line you want to cross and then use line segments on either side.

I have to use a similar method for rounding corners of lines when they meet at 90 degrees since Draw lacks the ability to round corners.